Grease gun manufacturer: operating procedures and requirements for grease gun

Operating procedures and requirements of electric grease gun manufacturer:
1. If there is a hard lever, you can pull the column for many times to reduce the volume of individual foam and mix the air inside with grease. This can solve the problem, but the effect is not always good.
2. The most effective method is defense. However, hardware support is required. Some gun bodies have an exhaust port design. Slowly open the vent screw, and the air will come out. Manufacturer of electric grease gun
3. The last is the final skill, which has been tried and built repeatedly. When you feel there is gas in it, the silk combined with the oil gun body and the pump body will rotate several times (it is better to press at the same time) to ensure your success. The reason is not difficult. That is to say, when you rotate, the gas foam inside is actually returning to other parts. The original parts are filled with lubricating oil, and the problem is solved.
1. Pull the pull rod to make the piston inside the cylinder close to the rear cover, and then lock the pull rod.
2. Install the lubricating oil into the cylinder. When using the oil machine, place the screw on the top of the oil barrel on the thin screw of the oil machine, and use the oil machine to load the lubricating oil into the liquid storage tank. If lubricating oil is directly applied to the cylinder by hand, first turn the front cover, then directly put the clean lubricating oil into the oil tank by hand until the entire oil tank is filled, then turn the front cover unlocking rod, and wipe the yellow oil gun with cotton yarn. Manufacturer of electric grease gun
3. Hold the oil barrel with one hand, and hold the hand column with the other hand. Squeeze the hand column repeatedly to exhaust the air in the barrel. Stop pressing the hand column when lubricating oil is found in the oil.
4. Aim at the main oil port in front of the main oil rod, firmly press it on the grease fitting at the position where the main oil is to be lubricated until it is not close to the main oil flow, then lift the hand column to the original position, raise it again, and press the reciprocating main pressure. The grease gun can be pulled out after the lubricating oil is filled at the position where the lubricating oil needs to be lubricated.
5. If the front end of the main oil rod of the grease gun is not convenient to access the main oil part to be lubricated, the main oil rod shall be sleeved with a hose and the cover shall be tightened to avoid leakage from the notch when lubricating oil is squeezed out. At the same time, install a spout and inner cap suitable for grease filling at the other end of the hose, insert the internal plug into the grease spout at the filling position, tighten the spout, and press.